这个神器才知道啊，哈哈

ghostmc 发表于 2019-1-13 16:02
1.试了三个U盘，只有一个能启动。
2.U盘启动后，能进入红黄灯闪烁，但未获得IP，无法网络连接（路由器上确 ...

1.U盘分区需要MBR格式，主分区，如果你做过WIN10的启动盘很可能变成GUID分区格式的！
磁盘格式用FAT把启动文件按格式拷贝进去！
2.一定要注意的是，实用U盘启动的时候，你原先的IP是肯定登陆不了的，IP会变成新的！建议百度下载netscan绿色版扫描IP地址
3.完成后重启，进入红灯，不能连接（插拨2次电源）那就多次每次等待2分钟左右
4.DEBIAN版就是这个问题，等空了搞个chroot版的就简单多了

谢谢分享！！！

感谢分享。。。。。。

支持一波！！！！！

不知道挂BT稳不稳定，有个七八百K都能满足了

楼主，请问我的GEN1刷完以后并没有进入debian，而是原系统还在。刷的最后显示“Configuring mdadm”这个，请问该怎么解决？putty在这里无法输入OK。
显示内容如下：
If the system's root file system is located on an MD array (RAID), it
  x needs to be started early during the boot sequence. If it is located on
  x a logical volume (LVM), which is on MD, all constituent arrays need to
  x be started.
  x
  x If you know exactly which arrays are needed to bring up the root file
  x system, and you want to postpone starting all other arrays to a later
  x point in the boot sequence, enter the arrays to start here.
  x Alternatively, enter 'all' to simply start all available arrays.
  x
  x If you do not need or want to start any arrays for the root file
  x system, leave the answer blank (or enter 'none'). This may be the case
  x if you are using kernel autostart or do not need any arrays to boot.
  x
  x
  x                                  <Ok>
  x                                                                          x
  mqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqj

老膜拜一下 大神

想试试，不知能否用得上

jjjjjjjjsssssssseds